Dawn Robotics Forum

I have connected up the XD-RF-5v to the mini driver A0. My purpose is for the receiver to grab the codes from the nexa home automation remote control and then the robot will be able to turn house lights and appliances on and off. However the data that I'm getting back through the isn't what I would expect.

754 755 755 755 755 755 0 755 0 0 0 0 754 754 755 753 751 754 754 753 755 755 756 756 755 756 755 755 755 755 755 755 754 0 0 0 0 756

This is before I have pressed the remote. When I press the remote it doesn't seem to make any difference. So not sure how to go further with this. Any help would be appreciated.

I'm using the raspberry pi 2 with the sensor code.

I'm afraid I don't have any experience with the XD-RF-5v, but a quick google seems to suggest that it's delivering a digital output rather than analog (apologies if I've misunderstood what you're doing).

This page seems to contain some sample code that might be useful, and it also contains a link to a library.

Regards

Alan