OSH Park
Profile for Red
Shared projects
[outdated][untested][super-difficult] 10mm DD + single 7135 w/ LFPAK33 v008
by
Red.
2
layer board of
0.40x0.40
inches
(10.03x10.03
mm).
Shared on
February 15th, 2015 15:25.
https://oshpark.com/shared_projects/WxbH4cRs
Don’t try this at home. Order one to cry over if you want.
Forum Thread: http://budgetlightforum.com/node/37726
[untested] [wip] 10mm LFPAK33 v003
by
Red.
2
layer board of
0.40x0.40
inches
(10.03x10.03
mm).
Shared on
February 14th, 2015 17:07.
10mm DD driver.
Forum Thread: http://budgetlightforum.com/node/37725
[outdated][untested][super-difficult] 10mm DD + single 7135 w/ LFPAK33 v005
by
Red.
2
layer board of
0.40x0.40
inches
(10.03x10.03
mm).
Shared on
February 14th, 2015 16:52.
Don’t try this at home. Order one to cry over if you want.
https://oshpark.com/shared_projects/wnoIDlj9
[untested] [wip] 17mm 8+1 x 7135 w/ cut-able 2nd channel v009
by
Red.
2
layer board of
0.67x0.67
inches
(17.02x17.02
mm).
Shared on
February 13th, 2015 03:59.
A17-L81
Forum thread: http://budgetlightforum.com/node/37686
22mm A22-7135 (22mm 7135) v022
by
Red.
2
layer board of
0.88x0.88
inches
(22.28x22.28
mm).
Shared on
January 31st, 2015 17:57.
v022: Added pulldown cap which occupies part of the same physical space as the Zener.
Forum Thread: http://budgetlightforum.com/node/31930
0805 sized resistors & caps.
Requires that the positions marked 7135-A and 7135-B have at least one 7135 populated each. Requires that the 7135 next to R2 be populated for the voltage divider to work (eg LVP).
Single-cell component list:
- R1 - 22k 1% resistor
- R2 - 4.7k 1% resistor
- C1 - 5uF/10uF/whatever capacitor
- OTC - 1uF capacitor
- D1 - low Vf diode for polarity protection
Zener components:
- R1 - appropriate 1% resistor
- R2 - 4.7k 1% resistor
- C1 - 5uF/10uF/whatever capacitor
- OTC - 1uF capacitor
- R3 - appropriate 0805 resistor, such as 200 ohm
- Zener - appropriate SOD-123 zener, such as 4.3v