
OSH Park
Shared projects
sensor-hub-pcb v0.1.5 20150911-1402
by
4
layer board of
1.00x4.42
inches
(25.27x112.27
mm).
Shared on
September 11th, 2015 18:01.
2 CH AMC7135 DRIVER
by
2
layer board of
1.01x1.00
inches
(25.55x25.27
mm).
Shared on
September 11th, 2015 14:44.
2 CH AMC7135 DRIVER
Arduino Dew Heater Control board
by
2
layer board of
2.24x2.00
inches
(56.82x50.80
mm).
Shared on
September 11th, 2015 11:37.
This board enables me to use two 12V RGB LED light controllers (check out ebay) for manual control of up to 6 dew heater bands. However I can also switch any or all the channels over for automated control using the Arduino and a temperature / humidity sensor.
This board has two switch ICs that switch over the control signal for each of the 6 channels between the manual Pot and the 6 channel digital Pot on this board.
If you add in 2mm JST connectors / cables and connec the connector from the manual Pots on the RGB dimmers, to this board (CH1_POT….) and then similar connects from this boards outputs (CH1_BO) back to the sockets on the RGB dimmer boards - then you have yourself a SPI controlled 6 Channel Dew Controller.
There are no passive components on the board, only power, ground, ICs and connectors. The power being used by the ICs is 5V.
USB3.0 TPS2514 Breakout
by
2
layer board of
1.12x0.53
inches
(28.52x13.51
mm).
Shared on
September 10th, 2015 20:12.
USB 3.0 pins broken out to pinheaders. USB power and ground pins broken out to KF301-5.0 terminal block. TPS2514 USB charging port controller added to D+ and D- lines (10W config). Working.
IR_Tower_RevA
by
2
layer board of
1.00x1.00
inches
(25.50x25.50
mm).
Shared on
September 10th, 2015 18:08.
IR Tower for Lego Mindstorms
First prototypes now being build. Firmware is being developed.