OSH Park
Shared projects
OBDII STN USB
by
d_dub07.
2
layer board of
2.71x1.71
inches
(68.81x43.38
mm).
Shared on
April 3rd, 2015 17:39.
v14 OBDII STN USB Code Reader
L298 Motor Driver Breakout
by
Heisenbug.
2
layer board of
2.40x1.73
inches
(60.99x43.82
mm).
Shared on
April 3rd, 2015 00:42.
$20.70 / set of 3 - untested (will update)
Motor driver chip good to ~40V / 2A cont (3A pk) and power dissipation limited to 25W or by size of the (probably insufficient as designed) heatsink used.
Screw terminals and Hard Disk power connector used for convenience. Need either a jumper or Rsense across each G/S (ground/sense) terminal pair, and a 7805 ONLY if supplying power solely via +Vmotor. Pads for either PTH or SMD resistor/LED pairs on motor outputs are independent from other half of each H-bridge; BOTH will light if pulled high.
Flyback clamping diodes are DO-214AC package/pads, and should be rated for at least 2A, 40-50V.
Hydro Shield v0.1
by
lostangles.
2
layer board of
4.00x2.10
inches
(101.70x53.44
mm).
Shared on
April 3rd, 2015 00:25.
Arduino Mega shield for hydroponics
Firefly v1.1
by
rogertheriault.
2
layer board of
1.42x0.51
inches
(36.02x12.95
mm).
Shared on
April 3rd, 2015 00:23.
Annoying gadget runs a week on one battery
RS-15 DED
by
Ryan-Summers.
2
layer board of
2.95x0.55
inches
(74.93x13.97
mm).
Shared on
April 2nd, 2015 23:47.
This is a signal bus board, acting like a slotting device for ease of connection between two edge connector slots.