[outdated] [untested] 17mm A17PZL v012

2 layer board of 0.67x0.67 inches (17.02x17.02 mm).
Shared on December 5th, 2014 06:45.

Replacement: https://oshpark.com/shared_projects/dC3iqMxp

EDIT, NOTE: PWM pins are hooked up backwards on v012, requires code changes in order to work right.

• added a covered 1mm via for SW+ hookup from rear, pass your wire through and just solder onto OTC pad if you want.
• improved LED- trace on bottom in order to facilitate the chunk eaten up by the 1mm via above.
• Increased LED+ and LED- vias to 1.3mm

Order board. Download. Permalink. Embed order link.

BMX055+MS5637+M24512DFM+EM7180TeensyShield.v01x

2 layer board of 0.71x0.51 inches (17.93x12.83 mm).
Shared on December 5th, 2014 04:31.

BMX-055 9-axis motion sensor plus MS5637 pressure sensor with the SENtral EM7180 sensor fusion hub with M24512DFM EEPROM to store the SENtral configuration file. SENtral takes 9-axis accel/gyro/mag from BMX-055 and performs hardware sensor fusion returning raw data, quaternions, linear acceleration, and heading, etc. First attempt at using wafer-level, chip-scale package (WL-CSP). Breakout board using the SENtral with jumpers to take power from edge pins for breadboard use or to mount directly on the Teensy 3.1 for comparison between open-source software sensor fusion and the hardware sensor fusion provided by the SENtral.

Order board. Download. Permalink. Embed order link.

Ethernet Breakout

2 layer board of 2.26x1.03 inches (57.48x26.06 mm).
Shared on December 4th, 2014 15:14.

Test board for ENC424J600

Order board. Download. Permalink. Embed order link.

WR703N Expander v1

2 layer board of 1.93x2.01 inches (48.92x50.93 mm).
Shared on December 4th, 2014 09:09.

WR703N Expander v1

Developed in conjunction with the Sydney Hackerspace Robots and Dinosaurs Inc – June 2012 (featured on Hack A Day 24th June 2012)

This project is a small USB Hub & FTDI dual serial/GPIO/JTAG adapter. It was designed to match the form factor of the TP-LINK WR703N router, but can be used with almost any USB host. If you haven’t used the WR703N - it is a great little OpenWRT box, made even better with the I/O expansion from this board.

http://www.kean.com.au/oshw/WR703N/

http://wiki.openwrt.org/toh/tp-link/tl-wr703n

2 layer board of 1.93x2.01 inches (49x51mm). $19.30 for three.

Order board. Download. Permalink. Embed order link.

blink(1)

2 layer board of 0.49x0.54 inches (12.34x13.74 mm).
Shared on December 4th, 2014 07:19.

USB led notifier

Order board. Download. Permalink. Embed order link.