ILI9431 Display (320x240) to Teensy 3.1

2 layer board of 1.80x1.48 inches (45.77x37.54 mm).
Shared on August 29th, 2014 19:32.

Newer Version Available

A new version of this board is available. It fixes problems with the reset signal and power jack.

You can easily identify the board version by the location of the 100 ohm resistor.

Old Info:

This is the little test board shown here:

http://www.pjrc.com/store/display_ili9341.html

Parts used on the board are:

    LM7805 voltage regulator        Digikey LM7805ACT-ND
    B130 Schottky diode             Digikey B130-FDICT-ND
    140 mA PTC fuse                 Digikey 507-1495-1-ND
    100 ohm 1/4 watt resistor       Digikey 100XBK-ND
    DC power jack                   Mouser 163-7620E-E
    1uF 0805 capacitor              Digikey 1276-1066-1-ND

This PCB has the display RST signals connected to pin 8, not 3.3V. This special step is needed to make it work.

Order board. Download. Permalink. Embed order link.

BMX055 Tiny Breakout

2 layer board of 0.25x0.50 inches (6.40x12.67 mm).
Shared on August 29th, 2014 19:02.

I2C Breakout for the BMX055 that is very small

Order board. Download. Permalink. Embed order link.

BMX055 Breakout - Tiny, Pads

2 layer board of 0.25x0.42 inches (6.40x10.69 mm).
Shared on August 29th, 2014 19:02.

A BMX055 Breakout that is very small and uses solder pads for I2C communication.

Order board. Download. Permalink. Embed order link.

Pca9548 A Breakout

2 layer board of 0.86x1.16 inches (21.87x29.49 mm).
Shared on August 29th, 2014 19:02.

Order board. Download. Permalink. Embed order link.

BNO055 I2C Breakout

2 layer board of 0.26x0.91 inches (6.50x23.04 mm).
Shared on August 29th, 2014 19:02.

Miniaturized

Order board. Download. Permalink. Embed order link.