Game Link Breakout Board

by Arno.

2 layer board of 0.43x0.57 inches (10.90x14.50 mm).
Shared on January 12th, 2017 15:46.

Breakout board for the Nintendo Gameboy Game Link cables.

Note that I would NOT recommend to use these. Replacement ports for the GBA are rather cheap and work way beter than this. However, if you want, you can use these and they might be “good enough” in some cases, but you will most likely have to sand off the mouse bites that OSH Park adds.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

Jordi Guerrero Zapata

by jordiguerrero.

2 layer board of 2.78x4.28 inches (70.64x108.74 mm).
Shared on January 12th, 2017 14:41.

Beaglebone Shield for FresonCam

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

FT-8x7 Bluetooth v3

by KC8UFV.

2 layer board of 1.06x0.57 inches (26.95x14.50 mm).
Shared on January 12th, 2017 14:37.

This is a small adapter board to use an HC-05 or HC-06 bluetooth serial adapter for a Yaesu FT-100, FT-857, or FT-897. The circuit is exactly the same as the one for the FT-817, just a slightly different mounting method for the LED and Mini-DIN 8 connector. SJ1 is used to provide V+ to the adapter to enable AT command mode on an HC-05. R1-R3 are identical values, and are used to convert the 5v TTL signal from the rig to the 3.3v signal expected by the bluetooth adapter. R4 is the current limiting resistor for using an HC-06, R5 is the current limiting resistor for the status LED for an HC-05. R4/R5 may be omited if you do not desire having a status LED. The voltage regulator is a AMS1117-3.3v or LM1117 3.3v regulator. This board is designed to go straight off the back of the radio and not interfere with any other ports. This board WILL NOT fit on the FT-817 when it is standing on it’s back feet, although otherwise it will work. When ordering this board, order it in the 2oz, or it may not fit between the connector’s pins.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

[Tested] MPS MagAlpha MA700 Breakout

by james.

2 layer board of 0.51x0.56 inches (12.85x14.12 mm).
Shared on January 12th, 2017 03:21.

Simple breakout board for the MPS MagAlpha MA700 Angular Sensor.

Note headers aren’t spaced for breadboarding, although they will work with some minor bending.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

Smart_Cane

by emaad22.

2 layer board of 2.40x2.90 inches (60.99x73.69 mm).
Shared on January 12th, 2017 00:31.

Smart Cane Control Board

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project