THS4522 Shield v1.1

2 layer board of 0.87x0.86 inches (22.02x21.84 mm).
Shared on September 30th, 2016 21:15.

Copy this HTML into your page to embed a link to order this shared project

Teensy LC BOB v1.5

2 layer board of 1.53x1.72 inches (38.76x43.69 mm).
Shared on September 30th, 2016 20:23.

Teensy LC BOB is a breakout board for the Teensy LC microcontroller that allows you to use screw terminals to attach things.

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 2.56x2.21 inches (65.02x56.01 mm).
Shared on September 30th, 2016 20:06.

Raspberry Pi Hat - I2C step motor driver based on the AMIS30624 or TMC222 drivers.

NOTE: Avoid using metal standoffs next to the GPIO connector as one of the mounting holes could short Vcc and Vss…

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 0.58x0.75 inches (14.78x19.15 mm).
Shared on September 30th, 2016 19:50.

This is a shrink of the sensor half of the high/low current combo sensor.

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 1.53x2.74 inches (38.96x69.70 mm).
Shared on September 30th, 2016 18:35.

Teensy LC BOB is a breakout board for the Teensy LC microcontroller that allows you to use screw terminals to attach things.

Copy this HTML into your page to embed a link to order this shared project