OSH Park
Shared projects
RC Model Light
by
RoboUlbricht.
2
layer board of
0.79x1.43
inches
(19.96x36.22
mm).
Shared on
September 25th, 2016 20:02.
3 short blinks with 3x 3W LEDs.
- Microcontroller - ATtiny85 (Arduino IDE)
- Video of blinks.
- Source code
- Schematic
Bare ESP-12F to Breadboard
by
OK2GND.
2
layer board of
1.50x1.10
inches
(38.20x28.04
mm).
Shared on
September 25th, 2016 19:53.
Bare ESP-12F to Breadboard. Not tested.
DIY-Audio (Vers. A4) for OSSC (v1.3)
by
borti4938.
2
layer board of
1.18x1.05
inches
(29.85x26.75
mm).
Shared on
September 25th, 2016 19:45.
Version A4: Now with a pad for pin 5 (MCLK).
Please use 0.8mm substrate thickness. More information about this PCB can be found here: Link to GitHub
DIY-Audio (Vers. A4a) for OSSC (v1.5)
by
borti4938.
2
layer board of
1.18x0.99
inches
(29.85x25.15
mm).
Shared on
September 25th, 2016 19:45.
Version A4: Now with a pad for IT6613E pin 5 (MCLK); this pin has to be lifted before connected.
Please use 0.8mm substrate thickness. More information about this PCB can be found here: Link to GitHub
DIY-Audio (Vers. A4b) for OSSC (v1.5)
by
borti4938.
2
layer board of
1.18x0.68
inches
(29.85x17.30
mm).
Shared on
September 25th, 2016 19:45.
Version A4: Now with a pad for IT6613E pin 5 (MCLK); this pin has to be lifted before connected.
‘b’-Version has pads for GND and audio (in) allowing installation with wires to the SCART jack instead of the ‘forks’ for attaching the PCB directly to it.
Thanks to Kel for this modification.
Please use 0.8mm substrate thickness. More information about this PCB can be found here: Link to GitHub