OSH Park
Shared projects
DuinoHat
by
TerryC.
2
layer board of
2.56x2.21
inches
(65.02x56.01
mm).
Shared on
September 20th, 2016 23:42.
Arduino compatible HAT for Raspberry PI
- Needs EEPROM programming to ensure serial console gets disabled on Pi.
- Bootloader should be compatible with STK500
RasPi WS2801
by
TerryC.
2
layer board of
2.56x2.21
inches
(65.02x56.06
mm).
Shared on
September 20th, 2016 23:12.
Basic interface for WS2801 strings, with ATX PSU control (on pads).
Suitable for use with OLA on Raspberry Pi.
Synapse v. 1.0
by
shaduzlabs.
2
layer board of
2.70x2.10
inches
(68.58x53.37
mm).
Shared on
September 20th, 2016 22:25.
CV/Gate I/O shield for Arduino
Remora
by
desimmon.
2
layer board of
2.10x2.00
inches
(53.37x50.85
mm).
Shared on
September 20th, 2016 21:16.
v1.1
Hi/Lo Current Sensor Combo Board
by
icenyne.
2
layer board of
1.06x1.53
inches
(26.92x38.86
mm).
Shared on
September 20th, 2016 19:44.
Current sensor board pair using TI’s INA250 and INA21x for high and low current measurements. Sensor board mounts up close to circuit under test, larger board provides connection for power and output signals, where an FPC cable connects the two.
Note: The holes for the banana plugs are a tad too large but will still hold in place. The footprint used for the INA21x was a tiny bit too large, so it doesn’t sit quite right on the pads but it can still be soldered into place.