OSH Park
Shared projects
Arduino Mega Shield - AD+STP
by
cm_development.
2
layer board of
3.43x2.10
inches
(87.15x53.26
mm).
Shared on
September 15th, 2016 08:09.
PCB for Arduino Mega Development
Antenna switch.brd
by
Midelic.
2
layer board of
0.87x0.73
inches
(22.10x18.47
mm).
Shared on
September 15th, 2016 07:23.
RF switch PE42641
One Watt Audio Amplifier - RevA
by
Blueberry.
2
layer board of
1.50x1.25
inches
(38.13x31.78
mm).
Shared on
September 15th, 2016 00:54.
Revised One Watt audio amplifier with a Mini USB port and a IS31AP4991A amplifier. C1 thru C3 are 1uF ceramic caps, C4 is a 100uF electrolytic. R1 thru R3 are 4.7k-ohm resistors. R4 and R5 are 47k-ohm for a gain of 10 (20 dB) on the amplifier. As in the previous one-watt amplifier, a stereo signal from the 3.5mm jack is combined into a mono signal using a simple resistor network. The USB input is only used as a 5-volt power source.
Sensorboard v4.2
by
z2amiller.
2
layer board of
1.67x0.77
inches
(42.32x19.46
mm).
Shared on
September 14th, 2016 20:08.
ESP8266 Sensorboard with switching regulator and BME280
9-Up cheapie XP V2.1
by
DavidEF.
2
layer board of
0.89x0.89
inches
(22.50x22.50
mm).
Shared on
September 14th, 2016 20:01.
9x Cree XP PCB for cheap 9-LED flashlights. Although the Cree XP LEDs have a separate, electrically neutral thermal pad, it has been joined with LED- on this board, to help spread heat away from the LEDs. Most LED flashlight drivers use the LED- for current regulation. This board won’t work with those drivers, unless you find another way to isolate the LED- from Batt- in your flashlight. It is meant to be a drop-in replacement in lights which don’t include a driver.