TV-B-GONE MICRO V1 - NOT TESTED

NickyYTSRB.

2 layer board of 0.52x0.52 inches (13.21x13.23 mm).
Shared on August 2nd, 2016 00:26.

Extra Small TV-B-GONE board. Details after testing.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

Zipit Z2 Breakout v2.0

mozzwald.

2 layer board of 2.96x0.66 inches (75.11x16.69 mm).
Shared on August 1st, 2016 22:18.

Zipit Z2 Breakout v2

Parts List

C1, C2: 4.7uF 6.3V 0603 (C1608X5R0J475K080AB)
L1: 1uH 0805 (LQM21PN1R0MC0D)
U1: TI 5V Regulator (TPS61240DRVT)
J1: Hirose to Zipit Connector (ST60X-36S)
J2: USB Host Port (292303-1)
J3: Amphenol FCI Micro USB Port (10118194-0001LF)
R1: 10K ohm 0603 Resistors (Regulator Enable)
R2, R3: 4.7k-10k ohm 0603 Resistors (I2C)
1.27mm Headers

Details

Both USB Ports are designed to be optionally broke off the middle section. Score the board with a blade on both sides down the line of holes and snap off the end. Each board when broken off can be used independently.

Main Zipit Board

This section of board contains the Hirose 36 pin connector, 1.27mm pitch headers, I2C resistors and “USB Jumpers”. The USB Jumpers allow connecting either the Micro USB (for device mode) or USB A (for host mode) port to the USB pins on the Zipit. The center pad of the jumper is connected to the Zipit. Bridge the center pad to the left or right pad with solder to set Host or Device mode.

USB-A Board

This section of board contains a USB A Port, 3.3V to 5V boost regulator, 1.27mm pitch header and jumper pads for the regulator and host power. When attached to the main Zipit board the “Host Pwr” Jumper sets which power is supplied to the port; DCIN from the Zipit or 5V from the regulator. The “Reg Jmpr” sets the regulator to be always “ON” or by toggling the “EN"able pin high (GPIO54 or via header).