nanoDLP

Any chance to get the estimated timestamp of print completion on the main page, for example on the "Remaining" line, like;
Remaining: 105 of 189 Mins (ETA 15:24)

I'm just so bad in time math

Could it be possible to allow going into HDMI Power Saving mode after print, and exit HDMI Power Saving mode before print ?

Going into HDMI Power Saving mode is achievable via

tvservice -o

But when exiting HDMI Power Saving, no picture/layers are shown anymore, via

tvservice -p && fbset -depth 8 && fbset -depth 16

Keep up the good work !

First, well done, you're doing a tremendous job! Keep up the good work.

I'm a bit puzzled with the Speed, Actuator/Motor settings (build 1039)... My printer (Morpheus Mark IV) has an Arduino Mega with a Ramp 1.4 and A4988 driving 2x Nema 17 motors for the Z axis.

The Lift and Sequence settings in Creation Workshop are :
- Z lift distance (mm): 10
- Z lift speed (mm/m): 250
- Z Bottom speed (mm/m): 250
- Z Retract speed (mm/m): 200

To stay on the safe side, I've kept the default Speed settings on nanoDLP:
- Max speed (µ/sec): 3000
- Min speed: 1000
- Motor startup speed: 100

And for Actuator/Motor settings, I've:
- Motor Step Angle: 1.8
- Microstep: 16
- Leadscrew Pitch (mm): 3 >> I'm not sure...
- Z-Axis Height (pulse): 3000 >> I have no clue...

As I haven't dared to start a print yet, I've just been playing with "Manual Move" under the Z-Axis Calibration tab.
When moving 50mm, the buildplate moves a few mm and halts, while the motors continue to make noise for a few seconds.

So my question is: could it be my Leadscrew Pitch is way off ? Why is this value needed (as Creation Workshop doesn't seem to need it...) ?
Also, could you elaborate on the Z-Axis Height (pulse) value please ?

Thanks!
Woale