You are not logged in.
Pages: 1
Is there a problem if i install python 3?
Hello.
To write up my building guide to the openajet one-m i'm optimizing the machine.
I now changed the raspberry and did a fresh installation to a raspberry pi 3 (before i used a rpi2).
I did a completly fresh installation but still have no access to my gpios. The Waiting pin has no effct, and the gio high or low command changes nothing (bevore on the rpi2 every thing was working fine, and i'm familar with your commands and the normal behavier).
i tried this but it affect none of the pins
[[GPIOHigh 3]]
[[GPIOHigh 4]]
[[GPIOHigh 5]]
[[GPIOHigh 6]]
[[GPIOHigh 7]]
[[GPIOHigh 8]]
[[GPIOHigh 9]]
[[GPIOHigh 10]]
[[GPIOHigh 11]]
[[GPIOHigh 12]]
[[GPIOHigh 13]]
[[GPIOHigh 14]]
[[GPIOHigh 15]]
[[GPIOHigh 16]]
[[GPIOHigh 17]]
[[GPIOHigh 18]]
[[GPIOHigh 19]]
[[GPIOHigh 20]]
[[GPIOHigh 21]]
[[GPIOHigh 22]]
[[GPIOHigh 23]]
[[GPIOHigh 24]]
[[GPIOHigh 25]]
[[GPIOHigh 26]]
[[GPIOHigh 27]]
[[GPIOHigh 28]]
[[GPIOHigh 29]]
[[GPIOHigh 30]]
[[GPIOHigh 31]]
[[GPIOHigh 32]]
[[GPIOHigh 33]]
[[GPIOHigh 34]]
[[GPIOHigh 35]]
[[GPIOHigh 36]]
[[GPIOHigh 37]]
[[GPIOHigh 38]]
[[GPIOHigh 39]]
[[GPIOHigh 40]]
i know this includes inaccessible pins it was just a try.
Shahin, wich lib do you use to access the gpios ?
Did you have already a report with similar issues?
Thank you,
AJ
from OPEN AJET Project
I just want to share my project which also uses NanoDLP
In 2014 I was interested to develop own MIDI controller for music productions.
The Midi controller should contain interchangeable and freely puttable elements.
I was sure to build a prototype of the MIDI-Board I would need 3D printer.
The printer should be above all one, high-resolution.
It was an other requirement that his building area would have at least a size from 250x250mm.
And to good one last he should be still favorable.
Each of you might know that there was not such a printer.
In any case, no printer which would do justice to all demands.
Quick it was clear that I would have to develop this printer myself. Aim was to be able to offer a professional printer for less than 500$.
After long development time and numerous invested hours, different prototypes he was born, the AJET ONE.
Now there he stood Printing for me!
Now I added up how much a serial production would cost, immediately it became clear to me that the aim of maximum 500$ can be never achieved.
I decided to develop a professional version of the AJET, the AJET Per. Because this will cost, however, far more than 500$, I have resolved to publish the plans for the AJET ONE free of charge.
It was an aim that nearly everybody can afford the AJET and now this becomes true.
I hope that together with the community wonderful project originates.
The Project ist called openajet now and the link is openajet.com
We selected NanoDLP due to the extreme good development work!! verry nice firmware shahin!
Pages: 1