You are not logged in.
Pages: 1
Hi shahin
With nanodlp can we send a signal out. I want a signal to control a relay to cut off power when it finish print. Can i do that, and how?
Thank you
it working, thank you very much shahih
Hi shahih,
Thank you for your support, i found the problem. I mistake between mm/min and mm/s, i edited and it work perfect. Thank you very much
And i have 1 problem , it about rs232 control projector
My projector is acer h6510bd
My setting is, baurate 11k, usb/serial ascii (\r)
Power on is *ir001, power off is *ir002
Usb port is usb 0->5, all i had try
But when i click project power on or of, it made nanodlp exit( my brower show error connection to internet), i must restart raspberry to use nanodlp again. :-(
Please tell me where fault, and how can i config its, thanh you ;-D
Hi shahin
Thank you for answer me.
I already set my firmware feedrate is 10, i use marlin muve firmware, but its not slow when i click zmove on z calibrate. When i use print auto it run normal, but when z move manual it fast and halt. I try many time but its not slow. What can i do, please help me. Thank you
Hi Shahin
Please help me, i have same problem with woale. I already set motor speed lower, but when i use move z manual, it still halt. When i use gcode, it ok. I think z movement halt because the motor speed, but i can't set it lower. However what i set on motor max min speed, it still move fast when i click move button on z calibrate.
Please help me how to set z speed on z calibrate slower. Thank you
Thank you
I have a question about stepperunit
I use step 1.8 degree, connect to ratio 10:1 and conect to lead screw 6mm per turn, full step
I had edit in marlin firmware stepperunit is 333.33, in nanodlp i set motor step 1.8, microstep 1, leadscrew 6. But it not correct
The distant lift is smaller. Please help me
Thank you
Hi admin,
I want use nanodlp with wifi connection, i already download nanodlp sd image card and burn it to sd card. When i install sd card to raspberry 3 , it boot up and show a black screen, i can type letter by keyboard but its not respon anything.
Please tell me when it show a black screen it already boot up and wait connect dlp or its fault.
I want use built in wifi of raspberry, how can i connect to wifi from a black screen to connect to network.
Thank you very much???
Pages: 1