You are not logged in.

#1 Re: Help and Support » Floor Button not working » 2016-04-03 08:47:19

That sounds great!

Thank you for quick reply,

#2 Re: Help and Support » Floor Button not working » 2016-04-02 21:03:25

Up and Down Buttons (200mm to 1Pulse) are working in right direction.
I´m using RAMPS - Zero at Bottom.
If I press "Home Z Axis" the axis will move to the bottom and stops at the end-stop - Position is set to 0 in nanodlp - so I think its correct.
If a slice is running, it moves to top, too - thats correct.
Only the "Floor Button" does nothing and if I press "Top Botton" it moves to bottom...

if I press "Measure Z length" and "Calibrate Zero Position" nothing moves... but should it ?!

Many thanks!

#3 Help and Support » Floor Button not working » 2016-04-02 12:07:49

Cobra
Replies: 10

Hi,

if I push the "Floor-Button" on the Z-Axis Calibration Tab, nothing happens but if I push the "Top-Button" the Z-Axis is moving down!?!
I working with Build 1107.

What´s wrong or is that a bug?

Many Thanks,
Cobra

Board footer

Powered by FluxBB