You are not logged in.
Pages: 1
Solved, thank you again ender67!!
Ok, i will try it. Thank you very much ender67!
Thank you ender67 for answering.
It is a 1440x2560 LCD, here it is the link where i buyed:
https://it.aliexpress.com/item/5-5-inch … fb9dJGEuG9
Hello guys,
I am trying building a LCD daylight 3d printer. I am practically a noob about raspberry pi 3 and informatics. I connected the LCD via HDMI and powered but the LCD is not working. When i turn on pi, the LCD backlight turn on but the screen is totally black. If I try to display projector calibration the screen remains black, but if click on "turn off projector" the LCD turn off. Where am i wrong?
On the setup page as "Projector communication type" I use "HDMI Power On/Off".
Thank you all
Solved. I took the wrong .tft file. After that, i put the screen.hmi file on nextion editor and compiled. Thank you for your guide!
Hi all,
I followed the guide of Tibus for the touchscreen on Nanodlp. I buyed the same nextion 2.4" NX3224T024_011 on the guide and in the attempt of update it, the device show this message "odel does not match Device Model: NX3224T024_011R". Can someone help me? Where i get wrong?
Thanks all
Hi all,
In the attempt of update the nextion 2.4" NX32247024_011, i get the message "Model does not match Device Model: NX3224T024_011R". Can someone help me? Where i get wrong?
Pages: 1