You are not logged in.
Pages: 1
I think it would be good to have a text field for each printer profile so the user can enter their own notes. One way this could be helpful is by allowing users to keep track of changes to the profile as they experiment and tweak it.
Thanks for your reply. My problem was I didn't notice I had accidentally left an extra space in front of my board path. Whoops. Your suggestion of checking the log helped me zero in on my silly mistake.
Thanks again.
Ontron, did you find a solution? I am having the same problem.
*I have verified that my RAMPS is working when I send gcode with another printer host.
*I can successfully connect to my RPi (I tried both a 2 and 3).
*The RAMPS board path is correctly set and I disabled GPIO.
I can't see what I'm missing. Any advice? I'm sure it's something obvious. Haha.
Thanks.
Pages: 1