You are not logged in.
Pages: 1
thanks,
I will have a try,and share if successed.
yangbo wrote:Currently,Nanodlp using top-down mode to build 3d model with projector on Top.
does nanodlp support bottom-up mode with UV light from bottom ?
thanks for your help.
I just completed my write up of my conversion from top-down to bottom-up.
It's here.
Thanks for sharing.
Which part need to change in Nanodlp's setup page to convert from top-down to bottom-up ?
my print platform will go to bottom when printing finished,this action will kill my LCD srceen(I am using 7' LCD + UV light position-fixed at bottom).
Is there some way to remove the last "go bottom" command in the printing process ?
thanks again.
Currently,Nanodlp using top-down mode to build 3d model with projector on Top.
does nanodlp support bottom-up mode with UV light from bottom ?
thanks for your help.
Pages: 1