nanoDLP

Yes removed them all :?

Ty!

its a monitor on LIPS technology.... I'll enquiry the manufacturer about it. I havent used it that much at all.

Hi!

I've re-downloaded NanoDLP SD image and re-burn it on SD card to start from scratch build 1209 as sgraber was reporting his HDMI came back to life.
I've manually typed all the settings to match printers' manufacturer settings.
I've manually copied and pasted their /boot/config.txt on my raspi as well.
I've tried THREE raspis.
I've tried THREE HDMI cables.
I've bought an HDMI to DVI conversor plug to try on the HDMI cable....

Motors work
LEDs work
but monitor won't block any light at all / display any patterns    

If I unplug the HDMI cable, NO SIGNAL appears on screen while UV lights are on, so somehow the signal arrives, BUT for whatever reason, it's NOT blocking the UV light as expected!

Anything else left to try?

I can't try CWS right now because I dont have an HDMI output on my laptop....

Advice please.

Thanks!

I meant HDMI on the Pi....

Any chances for downgrading or making older versions available just for test purposes?

Im not even able to get patterns nor text on bootup to display....

My first asumption was something changed on the HDMI handling but that did last until i decided to go jesse and latest nanodlp

Then it wont work neither on raspi2 nor raspi3....

Yes, everything up to date here too and printer/projector turned on before rpi.

I ask because unless I've missed something, my router uses port 80 as well for remote admin, so if I use the 80 port to remap it to an internal ip (nanodlp) then i loose router admin.

I installed a cam module on the pi, enabled using raspi-config and updated to latest nanodlp version. Rebooted the whole thing. I can't see anything. How do I get nanoDLP to show current image of the webcam, if possible?

Or is it only available whenever print is launched?

thanks

awesome, thanks guys!