You are not logged in.
Pages: 1
Is it possible to connect the RPi to a computer via ethernet and have the computer connected to the wif-fi, providing a bridge connection to the RPi?
The only way I have been able to see that screen besides the picture located on the dashboard tab is in the demo tab, which I am unable to change. How do I open that page for my printer?
How do I navigate to the nanodlp setup page?
After connecting to the Wi-Fi, I am able to see my printer on my local network. However, I am unsure on how to set up the "Online Access Key". Is this to be done on the Raspberry Pi or is there somewhere else on the nanoDLP website to do this?
Thanks!
After following the Simple Downloading step-by-step and powering on my Raspberry Pi, my Pi runs through some initialization and then goes to a black screen which I can type on but does not run commands. Is this what is supposed to happen? Am I only supposed to be able to control the Pi via Wi-Fi connectivity? I am unable to find my Pi when visiting the Online Dashboard, although this may be because I am running my Pi off of my university's network. I plan to try again on my home network later today.
Any help is greatly appreciated! Thanks!
Pages: 1