You are not logged in.
Pages: 1
i used the firmwear on the downloads page, how do i find out what code to use?
don't people use shutters with nanodlp all the time?
ive tried connecting it to the raspberry pi but thats not working
not sure if that'll work and im too afraid to try cos its a metal gear servo aha
ive got everything else set up but i can figure out how to set up the servo
it moves through manual control, the motor dont move while printing though
fixed, now all i need to do is make the motor move between layers, is there a code that i can copy and paste into the profile or is this an issue with something else?
this helped alot! i also discovered the other issue and that was that the end stop signal was inverted
is there a way in the software or firmware to update this to correct it?
not error messages, just red messages
i plug in the arduino, open marlin using the loader, then when i go to verify the code it comes up with a bunch of error messages but i can still upload it
is it normal to see error messages when uploading marlin? even if it says at the end that the upload is done?
figured out what half the issue was, driver burnt out, still not getting the enable/disable motor control option
im using the pi 3
Debug 4 2017-03-04 17:03:00.530309 WiFi Connected to
Debug 4 2017-03-04 17:02:40.070581 WiFi Status Monitoring
Warning 4 2017-03-04 17:02:40.070292 WIFI WIFI interface wlan0 detected
Notice 4 2017-03-04 17:02:39.891268 Terminal Terminal Reader Activated
Debug 4 2017-03-04 17:02:39.891208 Shutter Shutter Close
Debug 4 2017-03-04 17:02:39.89114 Hardware Stepper motor enabled
Error 4 2017-03-04 17:02:39.842685 SLAVE Serial port could not be activated open /dev/ttyUSB0: no such file or directory
this is what ive gotten
im getting
Warning 3 2017-03-04 16:33:30.093346 Terminal Problem Reading Terminal EOF
Error 3 2017-03-04 16:33:30.093112 SLAVE Serial Communication Error EOF
the ramps board and drivers work ive dose the test script on it already, i have the marlin firmware loaded onto it that is linked on the downloads page.
i did that and got it connected but now i can't get the motor to move using the ramps
ill try that thank you
ive loaded the image onto the sd card and set the wifi and password it just wont show up on the home network
what do i do?!
Pages: 1