You are not logged in.
Pages: 1
hello ,
my printer resolution is 1920 x 1080
and i have added this to my setting of nanodlp
my projector projected length and width is 192x108 and i have added x/y resolution is 100 micro is setup
problem :when i add the cube square of 60mm x 60mm x60 mm (length ,width , height ) i get result 92 x92 x 60mm.
can some one guide me how to remove the size error
In Projector i have used
Projector
i have selected "excution only "
previously it displayed
but now its not turning on my projector
should i need to re install the projector
i have an hdmi supported projector
i do not know what is the problem with pixels , but i am not getting the actual size ,please let me the if i am doing any thing wrong
well the part gets over lapped when i use x/y 115 and keeping y empty .
trying with 115 , but can you tell me how did you calculated sir ?
it will take a minute for any one to reply
i have tried lot of solution
i have a projector having resolution of 1920x1080 , 1080p and my projected width 220mm and height was 128 mm
what values should i keep in to set the projector value in projector
1) resolution width
2) projector resolution height
3) x/y resolution
4) y resolution
Pages: 1