You are not logged in.
Pages: 1
Thanks Adam, i'll try it this week-end!
Hi, I am looking for the STL file in this image : http://deezmaker.com/i/Bukobot-3D-Print … est-01.jpg
I want to compare the resolution of my print with this one!
Any ideas where I could find this?
Thanks Shahin, I just realised that I confused SLC with STL, I installed Asigna Stomp to create the SLC files and my printer reads them flawlessly. Everything is fine!
Hi,
I am trying to print SCL files but I cannot select the files when Im trying to add the plate. What should I do?
I am currently using Slic3r and exportig files to svg format to print a part but I tought that NanoDLP was also slicing the parts.
Many thanks!
Hi,
When I plug in my RPi the z axis starts moving for 125 000 mm. I cant stop it. Is it possible to add a button in the Z axis calibration that could stop all pulses sent from the pi?
Thanks!
No, only the top button lowers the platform when Im already at bottom.
I have build 1005, is this the lastest?
Thanks Sahin, but what i mean is that when I set the height of the Z-Axis and then I press the floor button, then the top button, the direction of the stepper doesent change and it keeps lowering instead of going up.
I am working only on direct GPIO control.
Hi,
I am currently triyng to calibrate the Z axis.
In the setup page, I used 500 pulse as height.
If I understand well, the limit switch is placed to the top, so when I use the Calibrate Zero Position Button in the Z axis Calibration page, the motor starts moving slowly until it hits the top limit switch then the current pulse value is set to Zero. Then, if I hit the Floor button, the motor moves to 500 pulse (since its the height). When it gets to the floor and I press the top button, the motor dont switch direction, but keeps lowering.
Am I the only one who have this problem?
Thank you very much!
Hey Mandreas, be sure to check this link from Pololu to set up the DRV8825 VREF voltage:
https://www.pololu.com/product/2133/faqs
Might save you some trouble!
Hi, I am currently trying to make my stepper work with the DRV8825. Just to be sure, the color code of the stepper is :
Black -->B2
Green -->B1
Red-->A1
Blue-->A2
Right?
Also, I dont quite understand how to use the Speed and Actuator/Motor settings in the Setup.
Suppose I want to use full steps and my motor has 1.8 degrees step angle and 200 steps per revolution
in the setup I would put these values :
Motor Step Angle : (1,8) Microsteps: (200)
If I want to change to use 1/16 steps, I would use these values?
Motor Step Angle : (0.11) Microsteps : (3200)?
Also, if I understand well, the pulse buttons in the calibrate section are independent of the Speed settings in the setup?
Hi,
I am trying to build a DLP printer with a RPi 2. I just came across the schematics and I cant identify what is the Max232 for.
Is it to be able to turn off the projector?
Also I tough that the PWM of the raspberry Pi could only be achieved with Pin 12-GPIO18 am I wrong?
Thanks a lot!
Pages: 1