Hi,
I just bought the Pi Co=op board and I'm new to Arduino. I followed the Simple install to a new Raspian and brought up the Arduino IDE ok. When I upload the Blink basic sketch I get a "Programmer not responding".
Any ideas?
"programmer not responding" IDE message
1 post
• Page 1 of 1
"programmer not responding" IDE message
by arnoldbail » Thu Jun 19, 2014 4:55 pm
- arnoldbail
- Posts: 7
- Joined: Thu Jun 19, 2014 4:40 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: Yahoo [Bot] and 1 guest