OSH Park
Profile for OnyxRobots
Shared projects
Darwin Mini Servo Hub
by
OnyxRobots.
2
layer board of
0.95x0.71
inches
(24.00x18.01
mm).
Shared on
May 1st, 2015 01:39.
Split the signal for a XL-320 servo four ways. Also provide interconnectivity with the AX-12A style servo bus.
Xbee to ESP8266 adapter
by
OnyxRobots.
2
layer board of
0.99x1.08
inches
(25.02x27.51
mm).
Shared on
January 31st, 2015 05:52.
Have an Xbee socket? Want to plug in a ESP8266 serial WiFi adapter? Look no further!
Undervoltge Lockout; Rev E2
by
OnyxRobots.
2
layer board of
2.00x1.50
inches
(50.80x38.13
mm).
Shared on
December 14th, 2014 03:22.
A new version of my successful UVLO circuit. This one has pushbutton power off in addition to the on that the previous had. It still uses an Atmega85, and the firmware for that chip is still important to the proper functioning. Ping me if you want it.
Mini 328 A
by
OnyxRobots.
2
layer board of
1.80x1.05
inches
(45.72x26.67
mm).
Shared on
November 15th, 2014 05:42.
2014-11-14 atmega 328 host board
Linear PSU 12V RevB
by
OnyxRobots.
2
layer board of
3.15x2.30
inches
(80.04x58.45
mm).
Shared on
August 23rd, 2014 19:46.
120V / 12V 1.4A PSU 2014-02-21
For a project where off-the-shelf switching power supplies all had too much coil whine, I designed this linear power supply. It is noise-less, and runs silently. It is designed to be plugged into mains, with proper creepage/clearance zones, but you have to use a separate fuse in the power entry module for the grounded box you should mount this in.
Output voltage is set by the R2/R1 divider; the transformer and application I use set this at 12.0V.
If you’re not comfortable designing for and working with mains voltage electronics, I recommend against trying this project.