OSH Park
Profile for Red
Shared projects
[OUTDATED] Firmware Developers Only - 17mm DD+7135
by
Red.
2
layer board of
0.67x0.67
inches
(17.02x17.02
mm).
Shared on
August 6th, 2014 13:55.
If you can’t figure out the component placements on a completely unlabeled board, this is not for you. This board does not have a firmware available. This board is untested. This board does not have the [June/July 2014] anti-boost fix incorporated, MCU voltage may go too high. Any silkscreen markings are arbitrary and have no meaning.
[outdated] 22mm 7135 v016
by
Red.
2
layer board of
0.88x0.88
inches
(22.28x22.28
mm).
Shared on
July 18th, 2014 05:15.
Replacement: https://oshpark.com/shared_projects/FQYMvlPm
0805 sized resistors & caps.
Standard Nanjg 105c components: 19.1k/4.7k resistors, C1, D1, etc.
Standard Zener setup: Replace D1 w/ 200-ohm or otherwise appropriate resistor. Populate large zener diode pads on top.
Offtime setup: Populate 0805 next to MCU with cap (1uF for example).
PIC to ATTINY v07 - LD29
by
Red.
2
layer board of
0.26x0.32
inches
(6.68x8.00
mm).
Shared on
July 10th, 2014 00:40.
Revised for use with an LD29 driver.
http://budgetlightforum.com/node/32648#comment-611634 (post#27)
26mm contact board v14
by
Red.
2
layer board of
1.03x1.03
inches
(26.11x26.11
mm).
Shared on
July 9th, 2014 18:02.
Bugfix over v13. Intended to be filed while spun on a 1/16in mandrel. Otherwise similar to v11: 16mm tabs for 17mm driver or file to the outside of the purple line to get a 18.08mm circle for a 20mm driver. Additional 0.2mm purple lines at 22mm and 24mm for cutting board down. Both sides have a full copper pour.
PIC to ATTINY v06
by
Red.
2
layer board of
0.26x0.32
inches
(6.68x8.00
mm).
Shared on
July 8th, 2014 02:48.
revised to stack rather than mirror the bottom (oops!)