OSH Park
Profile for goboxgizmos
Shared projects
50W 20/40dB RF Attenuator
by goboxgizmos.
2
layer board of
1.87x0.41
inches
(47.50x10.34
mm).
Shared on
August 22nd, 2014 14:31.
http://g7ltt.blogspot.com/2014/08/20db-or-40db-rf-attenuator.html
ACME router to OpenGear Console Server adapter
by goboxgizmos.
2
layer board of
1.43x0.66
inches
(36.32x16.69
mm).
Shared on
August 18th, 2014 16:26.
An in-line adapter to allow connection from Acme router/SBC hardware to OpenGear Console Server hardware.
Beaglebone Black GPS Mini-Cape
by goboxgizmos.
2
layer board of
2.36x1.07
inches
(59.97x27.18
mm).
Shared on
August 9th, 2014 21:06.
Primarily for use as an NTP source this cape fits inside most enclosures. Uses Ublox NEO-6M etc. Derived from http://the8thlayerof.net/2013/12/08/adafruit-ultimate-gps-cape-creating-custom-beaglebone-black-device-tree-overlay-file/
Arduino with Ethernet
by goboxgizmos.
2
layer board of
3.50x2.00
inches
(88.90x50.75
mm).
Shared on
August 5th, 2014 23:21.
This is a ‘328 compatible board with ENC28j60 Ethernet (etherCard library). The original is from “drj113” over at http://www.instructables.com/id/A-credit-card-sized-Ethernet-Arduino-compatable-co/.
His board was laid out in KiCAD which I don’t use so I converted it to Eagle and also swapped the SMD parts for regular ones. I replaced the DIP Switches with a dual header thus allowing the recovery of the analog inputs if desired. I use DHCP wherever possible and so selecting a fixed IP (see the Instructable) is very limiting for me as well as requiring me to write stuff down.
I needed a few boards for some “embedded” projects around the shack. One of these boards will get pressed into service as an NTP clock with 20x4 LCD making use of the I2C pins to run the LCD.
FT817/857/897 Remote Keypad
by goboxgizmos.
2
layer board of
2.51x3.46
inches
(63.75x87.88
mm).
Shared on
July 19th, 2014 13:14.