Shared projects

RPi PWM Level Shifter Hat

by jer.
Top
Bottom

2 layer board of 2.56x2.23 inches (65.10x56.62 mm).
Shared on August 14th, 2016 15:29.

Raspberry Pi Level Shifter Hat for driving WS2812/SK6812 LEDs.

Parts Required: - 1 TX0104 (TSSOP14) - 2 10uF (SMD 1206) Capacitors - 2 0.1uF (SMD 0603) Capacitors - 1 Schottkey Diode (SMD 1206) - 1 2A Fuse (SMD 1206) - 1 100mil Raspberry Pi GPIO Female Header

For more information, please see: https://github.com/jgarff/rpi_ws281x

Please note, when not powering the PI from the HAT, remove F1. If powering the Pi from the hat, be sure to only use a 5V regulated power supply with enough current capacity. This hat does NOT protect against over-voltage on externally connected supplies!

Use at your own risk. I take no responsibility for any damage or injury. This board has been tested and is known to work on Raspberry Pi B+ and later revisions.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project