Shared projects

ESP8266 breakout board

by plogen.
Top
Bottom

2 layer board of 0.91x0.91 inches (23.16x23.16 mm).
Shared on April 14th, 2015 15:11.

ESP-07 / ESP-12 breakout board

  • IC1 AMS1117 3,3V Vreg
  • MicroUSB connector
  • Tactile switch for programming mode
  • C1 10uF 0805
  • C2 10uF 0805
  • C3 0,1uF 0603
  • R1 10k 0603 Pull-up to 3,3V
  • R2 0Ω 0603 “Solder bridge”
  • R3 0Ω 0603 “Solder bridge”
  • R4 0Ω 0603 “Solder bridge”

When the switch is pressed it ties GPIO0 to GND through R2. This should be done during power up to enter programing mode.

R3 ties CP “CH_PD” to VCC. It should be so except for power down mode.

R4 ties GPIO15 to GND for both normal and programming mode.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project