MTN-SLdd v1.2

by MTN.
Top
Bottom

2 layer board of 0.48x0.45 inches (12.12x11.33 mm).
Shared on March 30th, 2016 03:53.

A small FET driver intended for a lot of the small twisty lights out there. Here are the differences from the other MTN-10/11/12DD drivers:

  • No copper around ground ring on component side. This makes isolating a twisty light much easier.
  • Different milled shape makes installation in a lot of the tiny twisty / clicky lights easier with less filing.

For a clicky light, if the battery tube does not touch the driver or you can’t solder to the pill, then this is not a good choice because you will have a difficult time getting a good ground.

The regular MTN-11/12DD is much better in these scenarios due to the exposed copper on the component side of the driver.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project