RFM23BPS / Arduino Nano Breakout

by phiatt.
Top
Bottom

2 layer board of 2.15x1.90 inches (54.64x48.29 mm).
Shared on December 8th, 2015 02:43.

RFM23BPS / Arduino Nano Breakout

Slight Change…Level converters are powered from Nano 3.3v regulator or on-board regulator.

Due to the 3.3v nature of the RFM23BP, I needed to be able to communicate with the transceiver via uart. This board has level translators interfaced with an Arduino Nano; all pins of the RFM23BP have interfaced with the Nano, except for the GPIO. The design has not been tested yet. Translators are BSS138 Mosfets, and 10K 0603 resistors. TX and RX are brought out to a pin header. As of 12/07/15, this design works well with RadioHead RH_RF22 driver, Thank Guys @ airspayce.com.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project