Raspberry Pi HUB75-Backpack v1.0

2 layer board of 1.39x0.60 inches (35.26x15.27 mm).
Shared on February 28th, 2015 04:26.

NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.

This board allows plugging a Raspberry Pi into a HUB75 compatible LED panel. The 26-pin female header for the Pi and the 16-pin tall stacking header for the HUB75 panel both attach to the back/bottom side of the board. The PCB hangs over the edge of the Pi and allows the Pi to plug directly into the back of the HUB75 panel. Pin 1 for the Pi is on the left bottom of the connector when viewed from the top of the board. Pin 1 for the HUB75 interface is the top right of the board. This PCB may also be used with a male header for the HUB75 panel attached to the top side of the board rather than a female header attached to the bottom side of the board.

Order board. Download. Permalink. Embed order link.