[untested] Stepper Signal Breakout Board V0.3

by Overtuner1.
Top
Bottom

2 layer board of 0.80x0.57 inches (20.32x14.55 mm).
Shared on February 5th, 2016 18:46.

small breakout board for using MCU pins on unused stepper sockets - especially when using more than one analog sensors on RADDS, more endstops than available onboard, fan or heater pwm outputs, whatever…

also connects the signals and power to the outputs - same way as the RRD Silencioso Adapter does.

fits RAMPS, RADDS and other controllers with sockets for standard A4988 and pin-compatible drivers

you should use a 3x3 right angle pinheader

V0.3 - moved conn for better wiring

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project