Atari Pause Mod V2.0B

by SwampFox56.

2 layer board of 0.89x1.08 inches (22.71x27.46 mm).
Shared on September 4th, 2016 06:10.

For the Atari 2600. Based on Victor Trucco’s schematic; this board intercepts the read, write signals from the TIA and 6507. Shorts them to ground which puts the processor in a “HALT"ed state.

TIA Pin 3 (RDY) has to be lifted, but Pin 3 (RDY) of the 6507 stays connected to the board. You can lift TIA Pin 3, but removing resistor R207 is exactly the same as lifting the pin. More advanced install instructions here.

http://www.coolretroprojects.com/Atari_2600_Pause_Mod_Installation_Guide.pdf

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project