esp8266 wroom-02 Breakout

by ChuckL.
Top
Bottom

2 layer board of 1.02x1.15 inches (25.91x29.16 mm).
Shared on April 17th, 2016 03:04.

Breakout board for the wroom-02. All pins are tied directly to their corresponding pad.

Short en to have the enable pin tied to power.

Add 10k resistors R1, R2, R3 to make the module go into flash boot mode on startup.

Add the KMR221GLFS switch so you can easily put the module into flash mode.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project