Raspberry Pi Hub75 v1.1

by CaptainMurdoch.
Top
Bottom

2 layer board of 1.44x0.65 inches (36.53x16.51 mm).
Shared on February 6th, 2015 20:46.

NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.

This board allows plugging a HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male header for the HUB75 connection attaches to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project