OSH Park
Shared projects
Universal RS-485/DMX Transceiver
by
nkaminski.
2
layer board of
3.31x1.66
inches
(83.97x42.06
mm).
Shared on
December 24th, 2015 06:24.
ESP-1-BB v0.1
by
SmittyHalibut.
2
layer board of
1.08x0.76
inches
(27.46x19.20
mm).
Shared on
December 24th, 2015 01:33.
NOTE: The 30uF spec’d on the board is not sufficient to let an (read: my) FTDI serial cable (mine is actually PL2032) power the ESP8266. The ESP draws down the power line too much and the serial chip looses sync with my PC’s USB host controller. Either add more bypass caps (100uF or so?), or power it from an external 3.3v power source.
An ESP-1 ESP8266 breakout board. Includes:
- Pins spaced for breadboard use
- An FTDI serial header
- Reset and Program buttons
- Optional solder-blob chip enable
- 10k pull-up on Reset
- 3x 10uF power bypass caps (needs more than this if you intend to power it from your serial cable)
To put the ESP8266 into the programming state, push and hold the Program button, then push and release the Reset button, then release the Program button. The ESP8266 is now in Program mode and appears to stay there until you upload your program.
Data Log PCB
by
Spilly.
2
layer board of
3.91x6.28
inches
(99.24x159.41
mm).
Shared on
December 23rd, 2015 20:22.
Data Log PCB
LED Board
by
TruckinGeek.
2
layer board of
0.80x0.60
inches
(20.32x15.27
mm).
Shared on
December 23rd, 2015 14:38.
Allows to have 4 LEDs and a couple of CAPs easy to hand for your proto board!
SousVide Controller
by
bc547.
2
layer board of
1.44x0.94
inches
(36.63x23.93
mm).
Shared on
December 23rd, 2015 12:33.
Prototype