OSH Park
Shared projects
- You need to sign in or sign up before continuing.
ESP8266_basic
by
gopiballava.
2
layer board of
1.34x1.09
inches
(33.91x27.56
mm).
Shared on
July 1st, 2015 13:37.
Basic proto board
Storm32 BGC MPU v0.09
by
irun4fundotca.
2
layer board of
0.60x0.71
inches
(15.34x18.01
mm).
Shared on
July 1st, 2015 12:48.
$2.10 for three
Storm32 NT Motor Module v0.09
by
irun4fundotca.
2
layer board of
1.55x0.78
inches
(39.37x19.71
mm).
Shared on
July 1st, 2015 12:48.
$6.00 for three
http://www.rcgroups.com/forums/showpost.php?p=32035018&postcount=82
Shuriken video V1
by
andre104623.
2
layer board of
2.24x1.02
inches
(57.00x25.93
mm).
Shared on
July 1st, 2015 11:58.
HDMI out for gamecube. UPDATE new flash made with spdif out for audio. Its on pin 8 of the spare connector (conn 5). Check out gc-forever.com for more details. Update 8/29/15: Now can output sound though HDMI connector but you will lose SPDIF output. Use version 0.2 for SPDIF output. Use version 0.5 for HDMI sound
To connect SPDIF output without killing the FPGA please use a buffer circuit or 3.3v capable SPDIF transponder
http://www.staffs2.webspace.virginmedia.com/video_schematic.pdf
C1 = 100nf C2 = 100nf C3 = 100nf C4 = 100nf C5 = 100nf C6 = 100nf C7 = 100nf C8 = 100nf R1 = 100k R2 = 330ohm R3 = 4.7k R4 = 4.7k R5 = 10k R6 = 10k R7 = 180ohm U1 = xc3s50a 100-pin U2 = m25p40 SPI U3 = 5v reg U4 = 1.2v reg HDMI connector 151-6661
ESP8266.v03
by
2
layer board of
0.71x0.86
inches
(17.96x21.74
mm).
Shared on
July 1st, 2015 09:53.
Simple breakout board for the ESP8266 chip to provide wifi capability to the Teensy 3.1. Designed to take power from VIN via USB or LiPo battery and convert to 3V3 with a TLV7333 300 mA voltage regulator. Also on board is a Macronix 4 Mbit MX254006E SPI Flash memory chip. Small leds indicate power on and RX, pcb antenna matched to 2.4 GHz. Can use either 26 or 40 MHz Seiko Epson crystal. The board has all GPIO pins broken out including SPI port.