OSH Park
Shared projects
TCPoke
by
WishfulCoding.
2
layer board of
1.00x0.80
inches
(25.50x20.42
mm).
Shared on
February 28th, 2015 08:04.
Internet of Pokemon
NavX Robot IMU
by
techplex.
2
layer board of
3.05x2.36
inches
(77.50x59.84
mm).
Shared on
February 28th, 2015 05:07.
MXP Expansion for RoboRio - Inertial Measurement Unit
Raspberry Pi HUB75-Backpack v1.0
by
CaptainMurdoch.
2
layer board of
1.39x0.60
inches
(35.26x15.27
mm).
Shared on
February 28th, 2015 04:26.
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a Raspberry Pi into a HUB75 compatible LED panel. The 26-pin female header for the Pi and the 16-pin tall stacking header for the HUB75 panel both attach to the back/bottom side of the board. The PCB hangs over the edge of the Pi and allows the Pi to plug directly into the back of the HUB75 panel. Pin 1 for the Pi is on the left bottom of the connector when viewed from the top of the board. Pin 1 for the HUB75 interface is the top right of the board. This PCB may also be used with a male header for the HUB75 panel attached to the top side of the board rather than a female header attached to the bottom side of the board.
Simon kit PCB
by
loans.
2
layer board of
1.59x1.71
inches
(40.41x43.41
mm).
Shared on
February 28th, 2015 01:24.
Soldering kit that is an implementation of the game Simon
See: the Github page.
SuperCIC+IGR 2013
by
mickednk.
2
layer board of
0.89x1.75
inches
(22.48x44.35
mm).
Shared on
February 27th, 2015 23:42.
SuperCIC and In-game reset