OSH Park
Shared projects
Zero Tiny BLE V2.0
by
micahpearlman.
2
layer board of
0.79x1.85
inches
(19.99x46.99
mm).
Shared on
February 6th, 2015 23:50.
First production run of Zero Tiny BLE
USB Audio DAC V2
by
lowderd.
2
layer board of
1.80x1.80
inches
(45.75x45.77
mm).
Shared on
February 6th, 2015 21:04.
Revision 2 of a USB Audio DAC based on a TI PCM2707
AJQuick 4-Axis CNC Controller Board
by
IOTLLC.
2
layer board of
7.20x2.20
inches
(182.91x55.88
mm).
Shared on
February 6th, 2015 20:52.
CNC Controller is a Unipolar Stepper motor controller based on the SLA7078MPR by Allegro Microsystems
Cat Laser Control Board
by
stuthedew.
2
layer board of
1.70x1.70
inches
(43.18x43.18
mm).
Shared on
February 6th, 2015 20:52.
See https://github.com/stuthedew/Arduino-Laser-Cat-Turret
Raspberry Pi Hub75-Dual v1.1
by
CaptainMurdoch.
2
layer board of
1.44x1.00
inches
(36.50x25.40
mm).
Shared on
February 6th, 2015 20:46.
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a set of HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The outputs are duplicates of each other, both outputs will display the same data. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male headers for the HUB75 connections attach to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.