OSH Park
Shared projects
Raspberry Pi Hub75 v1.1
by
CaptainMurdoch.
2
layer board of
1.44x0.65
inches
(36.53x16.51
mm).
Shared on
February 6th, 2015 20:46.
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male header for the HUB75 connection attaches to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.
Icetube Clock - Transistor - Rev C
by
PhilD13.
2
layer board of
4.50x1.08
inches
(114.40x27.36
mm).
Shared on
February 6th, 2015 20:12.
A version of the Adafruit Icetube clock main board that will accept either a ZVP2110A FET (use a jumper wire for R6) or a PN2907 transistor for Q3 and use 470 ohm (min value) - 1K ohm (max value) for resistor R6. Suggest using firmware found here for the clock. https://github.com/johngarchie/xmas-icetube/
PowerDC
by
Drwizard.
2
layer board of
1.85x1.44
inches
(46.99x36.50
mm).
Shared on
February 6th, 2015 17:21.
Batterry Charger, Power Selector, DC-DC
HumiditySensorAC
by
sir066.
2
layer board of
1.34x0.50
inches
(33.96x12.70
mm).
Shared on
February 6th, 2015 15:00.
Simple AC soil humidity sensor adapter for various MCU
Alps EC11K15 breadboard helper v1.1
by
djm.
2
layer board of
1.20x1.00
inches
(30.48x25.43
mm).
Shared on
February 6th, 2015 12:38.
A breadboard adapter for an Alps EC11K15 rotary encoder that includes pullup resistors and debouncing caps. Connector pins ensure the helper board sits firmly on the breadboard beneath.