OSH Park
Shared projects
PDB36
by
TimKostka.
2
layer board of
1.42x1.42
inches
(36.07x36.07
mm).
Shared on
January 2nd, 2015 22:23.
The PDB36 is a power distribution board for a quadcopter in a 36mm form factor.
A 0.001Ω power resistor is included for current monitoring.
This board is meant to stack below the OSD36 board.
Quadrocopter Power Adapter
by
jsully.
2
layer board of
0.63x1.51
inches
(16.05x38.30
mm).
Shared on
January 2nd, 2015 22:17.
Adds micro USB charging and on/off switch to the Syma X1 quadrocopter.
Arduino IR Multiplexer Shield
by
FamousJameous.
2
layer board of
2.09x2.75
inches
(53.04x69.85
mm).
Shared on
January 2nd, 2015 20:27.
Multiplexes control of four IR devices.
Piranha LED Carrier Boards
by
n0mjs710.
2
layer board of
5.56x0.65
inches
(141.33x16.54
mm).
Shared on
January 2nd, 2015 19:15.
Each PCB contains 8 individual board that you “snap” apart. Each board holds one piranha LED and a current limiting resistor. The 10-pin dual-row header uses two pins for ground (return) and the 8 remaining are each used on one board. This allows one to use a ribbon cable to access 8 LEDs in “parallel”. Originally created to build an 8x8 matrix of LEDs with 16 I/O lines.
A MCP23S17 and MOSFET driver board intended to be used with these boards is located here:
https://oshpark.com/shared_projects/ZkcYL0bz
Ansible 2.4GHz XCVR by InsapioLC
by
insapio.
2
layer board of
0.87x0.84
inches
(22.20x21.26
mm).
Shared on
January 2nd, 2015 05:42.
Long range, low power, high data rate transceiver.