OSH Park
Shared projects
AVR ISP Pogo Adapter v0.1
by
nsayer.
2
layer board of
0.70x0.90
inches
(17.78x22.89
mm).
Shared on
October 7th, 2014 01:43.
Same as Sparkfun’s, but without the extra junk.
MSP430AFE253 Development Board
by
CascoLogix.
4
layer board of
1.02x2.02
inches
(25.81x51.21
mm).
Shared on
October 6th, 2014 21:43.
A development board for the MSP430AFE253
Picomotor
by
Kilohercas.
2
layer board of
1.58x2.36
inches
(40.00x60.02
mm).
Shared on
October 6th, 2014 19:23.
Picomotor driver
FPV Micro Diversity Controller
by
screamercx.
2
layer board of
0.80x0.74
inches
(20.32x18.80
mm).
Shared on
October 6th, 2014 10:53.
corrected + and - on silk screen
based on design by rcmodelreviews (Bruce Simpson)
0805 resistors, caps and LEDs SOIC14 op-amp and bilateral switch
you have to calculate the resistor value for LEDs according to LED specs/input voltage
BMX055+MS5637+EM7180SENtralSensorFusionHub.v01
by
2
layer board of
0.71x0.51
inches
(17.93x12.83
mm).
Shared on
October 6th, 2014 04:40.
BMX-055 9-axis motion sensor plus MS5637 pressure sensor with the SENtral EM7180 sensor fusion hub with M24512DFC EEPROM to store the SENtral configuration file. SENtral takes 9-axis accel/gyro/mag from BMX-055 and performs hardware sensor fusion returning raw data, quaternions, linear acceleration, and heading, etc. First attempt at using wafer-level, chip-scale package (WL-CSP). Breakout board using the SENtral with jumpers to take power from edge pins for breadboard use or to mount directly on the Teensy 3.1 for comparison between open-source software sensor fusion and the hardware sensor fusion provided by the SENtral. Four major digital components on a 0.5 in x 0.7 in board requires use of 0402 passive components and a lot of vias!