OSH Park
Shared projects
- You need to sign in or sign up before continuing.
Arduino Yun PowerStack 0.1
by
sirkha.
2
layer board of
2.10x2.70
inches
(53.44x68.68
mm).
Shared on
September 6th, 2014 12:53.
This not-quite-a-shield provides a barrel jack for the YUN, with a 5V LDO regulator and raises the board enough to put normal shields on without an issue.
Also included are two JST connectors and a prototyping area. One of the JST connectors is wired to the 5V input of the LDO and the other to the 5V output of the LDO. The prototyping pads are an experiment. A ground line and a power line run down the middle. The power line comes from the Yun’s 3.3V or 5V line and is selectable by jumpering the right angle connector to one side or the other.
NOTE: The silkscreen for this is not very good and may be refined in a subsequent version, if I feel like it.
NOTE: The slots for the barrel jack didn’t upload correctly. I routed mine out with a small drill bit, but I will probably fix this later with better features.
OWHL CPU RevB
by
millerlp.
2
layer board of
1.46x1.46
inches
(37.08x37.08
mm).
Shared on
September 5th, 2014 22:42.
Open Wave Height Logger CPU revision B
OWHL MS5308 RevB
by
millerlp.
2
layer board of
1.46x1.46
inches
(37.08x37.08
mm).
Shared on
September 5th, 2014 22:42.
Open Wave Height Logger MS5803 revision B
OWHL Power RevB
by
millerlp.
2
layer board of
1.46x1.46
inches
(37.08x37.08
mm).
Shared on
September 5th, 2014 22:42.
Open Wave Height Logger Power revision B
sot23/SC70-dip adapter
by
rkovvuri.
2
layer board of
0.30x0.40
inches
(7.62x10.16
mm).
Shared on
September 5th, 2014 19:28.
sot23/SC70 to dip adapter