OSH Park
Shared projects
Rigidbot Dual Ribbon Breakout Board v2
by
nemith.
2
layer board of
1.13x4.82
inches
(28.65x122.30
mm).
Shared on
September 5th, 2014 05:02.
Breakout board for the ribbon cables coming from dual extruders and heated bed.
Rigidbot Ribbon Breakout Board v2
by
nemith.
2
layer board of
1.12x2.62
inches
(28.40x66.42
mm).
Shared on
September 5th, 2014 04:28.
Breakout board for the ribbon cables coming from the extruder and heated bed.
USB-IF232-C
by
evilxyzzy.
2
layer board of
1.93x0.87
inches
(49.02x22.02
mm).
Shared on
September 4th, 2014 22:19.
Optoisolated USB version of Kenwood IF232C. Radio side pin numbers correspond to connector.
Computer side uses standard Arduino TTL-Serial/USB cable.
Radio side of circuit is a clone of the original.
Board slides into slots in Jameco 18922 case.
Board has been tested with TS440 and works. Should work with any Kenwood radio with the appropriate serial port.
S1100 Parallel Battery Pack Boards
by
Mattaus.
2
layer board of
1.57x1.57
inches
(39.78x39.78
mm).
Shared on
September 4th, 2014 12:36.
Single board works for both ends with stock battery springs and contacts.
WS2812B Ring Board Section
by
vectorspace.
2
layer board of
1.36x0.46
inches
(34.49x11.76
mm).
Shared on
September 4th, 2014 12:27.
Solder four together to make a ring of twelve WS2812B RGB LEDs. (Tested-Good)