OSH Park
Shared projects
FTDI Breakout Board
by
themacman33.
2
layer board of
1.50x1.00
inches
(38.13x25.43
mm).
Shared on
May 18th, 2014 16:47.
USB-> Serial Board
DDL
by
kc9on.
2
layer board of
0.61x0.83
inches
(15.54x20.96
mm).
Shared on
May 18th, 2014 15:27.
Adapter
CTCSS
by
kc9on.
2
layer board of
1.85x1.75
inches
(46.99x44.35
mm).
Shared on
May 18th, 2014 15:26.
Tone Board
CC-Dbg-TC2030-Adapter v1.0 Rev-B
by
drmkroll.
2
layer board of
1.19x1.00
inches
(30.15x25.40
mm).
Shared on
May 18th, 2014 14:56.
This is the CC-Debugger TagConnect 2030 Adapter I created to flash my BLEbee’s firmware. I described the use of the adapter in the following blogpost: http://www.mkroll.mobi/?p=1639
The Eagle source files are available from the github repository at: https://github.com/michaelkroll/Hardware-Tools
BLF TINY10
by
Helios-.
2
layer board of
0.42x0.42
inches
(10.62x10.62
mm).
Shared on
May 18th, 2014 04:45.
Includes paste layers. Can be used at oshstencil.com. Board created by Mattaus.
10mm Nanjg 105C compatible LED/flashlight driver.
Diode D1 is a BAT54.
C1 is 10 uF.
Resistors are 19.1K and 4.7K, 1%
Regulator chips are AMC7135
Processor is ATTINY13 or similar
LED connects to the + and – holes. Outer ring is ground.
Battery plus connects to + from the reverse side.
The driver mode configuration “stars” are marked 2 to 4 on the MCU side of the driver.
BLF discussion thread: http://budgetlightforum.com/node/24953#comment-550914