OSH Park
Shared projects
ATtiny 85 debug LED shield
by ATtiny_85.
2
layer board of
1.43x0.91
inches
(36.30x23.14
mm).
Shared on
May 4th, 2014 01:33.
An ATtiny 85 shield with an LED on each I/O pin, that can be enabled and disabled, for easy debugging and a reset switch.
ATtiny 85 breakout board
by ATtiny_85.
2
layer board of
1.11x0.84
inches
(28.27x21.39
mm).
Shared on
May 3rd, 2014 22:22.
An ATtiny 85 breakout board with power indication LED
Light module (parallel)
by johnwalthour.
2
layer board of
0.91x0.39
inches
(23.01x9.80
mm).
Shared on
May 3rd, 2014 22:02.
Gangs three Luxeon 3535L packages in parallel. Exposes a large groundable heatsink on the back. Has a notch in each end to facilitate screw mounting. Has a spot for a chip resistor in series with the LEDs.
Note that this design contains two boards to meet OSH Park’s minimum size requirements. That is, if you place an order for 3 instances of this design, you will receive 6 small boards.
Voltage regulator board
by johnwalthour.
2
layer board of
2.00x1.50
inches
(50.80x38.13
mm).
Shared on
May 3rd, 2014 22:02.
This is a carrier board for any TI LM2576 buck downconverter
SSREG Rev B
by dbit.
2
layer board of
2.10x1.25
inches
(53.37x31.78
mm).
Shared on
May 3rd, 2014 21:33.
NatSemi Simple Switcher regulator board. Can be stuffed with different parts to get different output voltages and current ratings. The point is to efficiently power 5V/6V/9V devices from a 12 V lead-acid battery.