OSH Park
Shared projects
CATS Alpha
by
ophilli.
2
layer board of
2.56x2.23
inches
(65.10x56.62
mm).
Shared on
October 25th, 2016 19:47.
CATS PCB
BuildLog.Net 3-Axis Laser Interface
by
Steele.
2
layer board of
4.60x3.60
inches
(116.89x91.47
mm).
Shared on
October 25th, 2016 16:23.
This is a corrected file for the 3 axcon
Ghetto PoE 5V v0.1
by
piersfinlayson.
2
layer board of
0.77x0.75
inches
(19.51x19.02
mm).
Shared on
October 25th, 2016 16:02.
Ghetto PoE 5V v0.1
A board designed to take 5v from a micro USB connector and send it down a CAT5/CAT6 cable for breakout and use at the remote end.
The board sends power down all 4 pairs, so the current carrying capacity is maximised, and should be good for around 500mA. Note that voltage drop will be an issue over long cable runs.
The BOM is pretty basic:
An RJ45 port, with LEDs (of which only the right, green, one is used to indicate power). I’ve used the Amphenol RJHS-4081.
Micro USB PCB mount connector. I use cheapos from aliexpress.
A current limiting 0603 resistor for the LED - I’m using a 1.5K to keep power use down.
A 1206 0.5A hold current, 1A trip current resettable fuse. I’m using Littelfuse 1206L050YR.
Gamecube Wasp/WKF Host QSB 2.3
by
citrus3000psi.
2
layer board of
0.94x0.71
inches
(23.77x18.11
mm).
Shared on
October 25th, 2016 15:00.
Fatshark Super module M2v1 !
by
Buzzfpv.
2
layer board of
0.99x1.71
inches
(25.15x43.31
mm).
Shared on
October 25th, 2016 13:49.
Buzz FPV electronics