THS4522 Shield v1

2 layer board of 0.87x0.87 inches (22.02x22.10 mm).
Shared on August 30th, 2016 15:34.

Copy this HTML into your page to embed a link to order this shared project

diy-striplight

2 layer board of 0.26x0.26 inches (6.48x6.53 mm).
Shared on August 30th, 2016 11:17.

carrier board for an 0603 LED with 2x plated holes for each terminal, to solder together on wires to use as a diy striplight

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 3.50x1.75 inches (88.93x44.48 mm).
Shared on August 30th, 2016 05:52.

rev B

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 1.53x1.15 inches (38.76x29.11 mm).
Shared on August 30th, 2016 05:36.

Breadboard-compatible board breaks out 9V, 5V, and 3.3V from a 9V battery using both through-hole and surface-mount components.

This is a good, useful design to practice soldering surface-mount parts. The pads are wide enough for reflow or a soldering iron.

Check out the Github repo for parts and assembly information.

This project is released under the Open Hardware License v1.2.

Copy this HTML into your page to embed a link to order this shared project

4 layer board of 3.08x3.08 inches (78.28x78.28 mm).
Shared on August 30th, 2016 05:14.

Not Tested Yet.

OpenPET Digital Detector Interface using HSMC Adapter for Cyclone V. This is used for the receiving side.

See OpenPET website for more info.

Copy this HTML into your page to embed a link to order this shared project